Physics, 10.11.2020 22:10 Jonah58

1.-) Se procede a realizar a lanzar ciertos objetos por medio de un equipo apoyado en el piso con un ángulo de inclinación de 45o , siendo disparados con una velocidad inicial de 180 km/h. Cuál sería la altura máxima alcanzaran los platos?

2.-) Se lanza unas pelotas con un disparador que tiene un ángulo de inclinación de 75o y con una velocidad de 25 m/s. Calcular:

a.) La altura máxima que alcanza las pelotas.

b.) El tiempo de vuelo que permanece en el aire.

c.) El alcance horizontal a que se caerían las pelotas al piso.

3.-) Un Objeto es lanzado y realiza un movimiento parabólico con una velocidad inicial de 85 m/s y un ángulo de 65o , Calcular el tiempo de vuelo del objeto lanzado.

Answers: 1

Show answers

Another question on Physics

Physics, 22.06.2019 09:40

When you jump from an elevated position you usually bend your knees upon reaching the ground. by doing this, you make the time of the impact about 10 times as great as for a stiff-legged landing. in this way the average force your body experiences is a) less than 1/10 as great. b) more than 1/10 as great. c) about 1/10 as great.d) about 10 times as great.

Answers: 1

Answer

Physics, 22.06.2019 17:30

Patricia is trying to compare the average rainfall of new york to that of arizona. a comparison between these two states for the months of july through september would best be measured in

Answers: 3

Answer

Physics, 23.06.2019 00:40

Asteel tube (k=50 w/mk) of inner and outer diameter di = 20mm and do=26mm, respectively, is used to transfer heat from hot gases flowing over the tube (h-hot = 200w/m2k) to cold water flowing through the tube (h-cold = 8000 w/m2k). what is the cold-side overall heat transfer coefficient uc? to enhance heat transfer 16 straight fins of rectangular profile are installed longitudinally along the outer surface of the tube. the fins are equally spaced around the circumference of the tube, each having a thickness of 2mm and a length of 15mm. what is the corresponding overall heat transfer coefficient uc? *solve for uc in both cases*

Answers: 1

Answer

Physics, 23.06.2019 08:30

Acertain half-reaction has a standard reduction potential e_red^0 = -0.94 v. an engineer proposes using this half-reaction at the cathode of a galvanic cell that e must provide at least 1.00 v of electrical power. the cell will operate under standard conditions. a. is there a minimum standard reduction potential that the half-reaction used at the anode of this cell can have? b. is there a maximum standard reduction potential that the half-reaction used at the anode of this cell can have?

Answers: 1

Answer

You know the right answer?

1.-) Se procede a realizar a lanzar ciertos objetos por medio de un equipo apoyado en el piso con un...

Questions