subject
Physics, 11.11.2020 22:50 namoralessimon03

A 5.0 Ω resistor is hooked up in series with a 10.0 Ω resistor followed by a 20.0 Ω resistor. The circuit is powered by a 9.0 V battery. ⦁ Draw a labeled circuit diagram for the circuit described using correct symbols.
⦁ Calculate the equivalent resistance.
⦁ Calculate the voltage drop across each resistor in the circuit.

For the labeled circuit diagram it doesn't have to be super detailed just a basic resistor circuit sketch like this but with the above information.


A 5.0 Ω resistor is hooked up in series with a 10.0 Ω resistor followed by a 20.0 Ω resistor. The c

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 22:00
In a wind tunnel the speed changes as the cross sectional area of the tunnel changes. if the speed in a 6' x 6' square test section is 100 mph, what was the speed upstream of the test section where the tunnel measured 20' x 20'? use conservation of mass and assume incompressible flow. conservation of mass requires that as the flow moves through a path or a duct the product of the density, velocity and cross sectional area must remain constant; i.e., that ova-constant. a model is being tested in a wind tunnel at a speed of 100 mph if the flow in the test section is at sea level standard conditions, what is the pressure at the model's stagnation point? (a) the tunnel speed is being measured by a pitot-static tube connected to a u- tube manometer. what is the reading on that manometer in inches of water? (b) at one point on the model a pressure of 2058 psf is measured. what is the local airspeed at that point?
Answers: 2
question
Physics, 22.06.2019 02:10
"an open tank has the shape of a right circular cone. the tank is 6 feet across the top and 5 feet high. how much work is done in emptying the tank by pumping the water over the top edge? note: the density of water is 62.4 lbs per cubic foot."
Answers: 2
question
Physics, 22.06.2019 17:00
Two conductors, a and b, are each in the shape of a tetrahedron. but of different sizes. they are charged in the following manner: 1. tetrahedron a is charged from an electrostatic generator to charge q. 2. tetrahedron a is briefly touched to tetrahedron b. 3. steps 1 and 2 are repeated until the charge on tetrahedron b reaches a maximum value. if the charge on tetrahedron b was q/4 after the first time it touched tetrahedron a. what is the final charge qbmax on tetrahedron b?
Answers: 2
question
Physics, 22.06.2019 18:00
Can you receive a shock severe enough to prevent you from releasing the wire from an ordinary outlet with dry hands? a. no b. yes explain
Answers: 1
You know the right answer?
A 5.0 Ω resistor is hooked up in series with a 10.0 Ω resistor followed by a 20.0 Ω resistor. The ci...
Questions
Questions on the website: 13722360