subject
Physics, 17.11.2020 01:00 meowmeowcow

In a warehouse, the workers sometimes slide boxes along the floor to move them. Two boxes were sliding toward each other and crashed. The crash caused both boxes to change speed. Based on the information in the diagram, which statement is correct? In your answer, explain what the forces were like and why the boxes changed speed. Box 1 has more mass than Box 2.
Box 1 and Box 2 are the same mass.
Box 1 has less mass than Box 2

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 17:20
You have been called to testify as an expert witness in a trial involving a head-on collision. car a weighs 1515 lb and was traveling eastward. car b weighs 1125 lb and was traveling westward at 44.0 mph. the cars locked bumpers and slid eastward with their wheels locked for 22.5 ft before stopping. you have measured the coefficient of kinetic friction between the tires and the pavement to be 0.750 . how fast (in miles per hour) was car a traveling just before the collision? (this problem uses english units because they would be used in a u.s. legal proceeding.)
Answers: 3
question
Physics, 22.06.2019 04:40
Which statement best describes copper? a. it has a low resistance and prevents charges from moving freely. b it has a high resistance and allows charges to move freely. c. it has a high resistance and prevents charges from moving freely. d. it has a low resistance and allows charges to move freely
Answers: 1
question
Physics, 22.06.2019 04:40
Argon is adiabatically compressed from an initial volume of 16 liters to a final volume of 2 liters. by what factor do the following quantities change? do they increase or decrease? (a) the rms speed (b) the thermal energy of the gas (c) the molar specific heat cv (d) the pressure
Answers: 3
question
Physics, 22.06.2019 04:50
Two technicians are discussing a resistance measurement between the can-h and can-l wires. technician a says this measurement should be done with the ignition switch in the "run" position. technician b states that a measurement of 0 ohms indicates an open in the network. which technician is correct?
Answers: 1
You know the right answer?
In a warehouse, the workers sometimes slide boxes along the floor to move them. Two boxes were slidi...
Questions
question
History, 16.04.2020 20:24
Questions on the website: 13722360