Physics, 03.12.2020 02:50 JeroMii

A ball of mass m moving with velocity v⃗ i strikes a vertical wall as shown in (Figure 1). The angle between the ball's initial velocity vector and the wall is θi as shown on the diagram, which depicts the situation as seen from above. The duration of the collision between the ball and the wall is Δt, and this collision is completely elastic. Friction is negligible, so the ball does not start spinning. In this idealized collision, the force exerted on the ball by the wall is parallel to the x axis. A) What is the final angle θf that the ball's velocity vector makes with the negative y axis?
Express your answer in terms of quantities given in the problem introduction.
B) What is the magnitude F of the average force exerted on the ball by the wall?
Express your answer in terms of variables given in the problem introduction and/or vix.

Answers: 2

Show answers

Another question on Physics

Physics, 22.06.2019 14:40

Glass has a hardness that is in the middle of the hardness scale. what is the hardness of glass?

Answers: 1

Answer

Physics, 22.06.2019 16:00

The field between two charged parallel plates is kept constant. if the two plates are brought closer together, the potential difference between the two plates either a) decrease b) does not change c) increase?

Answers: 3

Answer

Physics, 22.06.2019 18:00

Astone is thrown with a speed v0 and returns to earth, as the drawing shows. ignore friction and air resistance, and consider the initial and final locations of the stone. which one of the following correctly describes the change δpe in the gravitational potential energy and the change δke in the kinetic energy of the stone as it moves from its initial to its final location? options a.δpe = 0 j and δke = 0 j b.δpe is positive and δke is negative c.δpe = 0 j and δke is positive d.δpe is negative and δke is positive e.δpe = 0 j and δke is negative

Answers: 3

Answer

Physics, 22.06.2019 20:50

An ideal otto cycle has a compression ratio of 8. at the beginning of the compression process, air is at 95 kpa and 27°c, and 750 kj/kg of heat is transferred to air during the constant-volume heat-addition process. assuming constant specific heats at room temperature, determine (a) the pressure and temperature at the end of the heat-addition process, (b) the net work output, (c) the thermal efficiency, and (d) the mean effective pressure for the cycle. (4390 kpa, 1730 k; 423 kj/kg; 56.4%; 534 kpa)

Answers: 1

Answer

You know the right answer?

A ball of mass m moving with velocity v⃗ i strikes a vertical wall as shown in (Figure 1). The angle...

Questions