Physics, 16.12.2020 16:40 tatertottheyoungin

Part A: The primary coil of a transformer contains 100 turns; the secondary has 200 turns. The primary coil is connected to a size-AA battery that supplies a constant voltage of 1.5 volts. What voltage would be measured across the secondary coil?
Part B:
A transformer is intended to decrease the value of the alternating voltage from 500 volts to 25 volts. The primary coil contains 200 turns. Find the necessary number of turns N2 in the secondary coil.
Part C:
A transformer is intended to decrease the value of the alternating current from 500 amperes to 25 amperes. The primary coil contains 200 turns. Find the necessary number of turns N2 in the secondary coil.
Part D:
In a transformer, the primary coil contains 400 turns, and the secondary coil contains 80 turns. If the primary current is 2.5 amperes, what is the secondary current I2?
Part E:
The primary coil of a transformer has 200 turns and the secondary coil has 800 turns. The power supplied to the primary coil is 400 watts. What is the power generated in the secondary coil if it is terminated by a 20-ohm resistor?
Part F:
A transformer supplies 60 watts of power to a device that is rated at 20 volts. The primary coil is connected to a 120-volt ac source. What is the current I1 in the primary coil?
Part G:
The voltage and the current in the primary coil of a nonideal transformer are 120 volts and 2.0 amperes. The voltage and the current in the secondary coil are 19.4 volts and 11.8 amperes. What is the efficiency e of the transformer? The efficiency of a transformer is defined as the ratio of the output power to the input power, expressed as a percentage: e=100Pout/Pin.

Answers: 3

Show answers

Another question on Physics

Physics, 22.06.2019 03:00

1. a net force of 100 newton’s is applied to a wagon for 5 seconds. this causes the wagon to undergo a change in momentum of

Answers: 1

Answer

Physics, 22.06.2019 06:30

2kg of refrigerant 134a undergoes a polytropic process in a piston-cylinder assembly from an initial state of saturated vapor at 2 bar to a final state of 12 bar, 80 degree c. a)determine the work for the process in kj. b)sketch the process on a p-v diagram.

Answers: 2

Answer

Physics, 22.06.2019 11:50

Two resistors r1 and r2 may be connected either in series or parallel across an ideal battery with emf ε. we desire the rate of energy dissipation of the parallel combination to be 8.75 times that of the series combination. if r1 = 105 ω, what are the (a) smaller and (b) larger of the two values of r2 that result in that dissipation rate?

Answers: 2

Answer

Physics, 22.06.2019 13:40

An ideal otto cycle has a compression ratio of 10.5, takes in air at 90 kpa and 40°c, and is repeated 2500 times per minute. using constant specific heats at room temperature, determine the thermal efficiency of this cycle and the rate of heat input if the cycle is to produce 90 kw of power.

Answers: 2

Answer

You know the right answer?

Part A: The primary coil of a transformer contains 100 turns; the secondary has 200 turns. The prim...

Questions