Physics, 18.01.2021 19:40 lovenahofer

A bullet of mass 10 g strikes a ballistic pendulum of mass 2.0 kg. The center of mass of the pendulum rises a vertical distance of 12 cm. Assuming that the bullet remains embedded in the pendulum, calculate its initial speed.

Answers: 2

Show answers

Another question on Physics

Physics, 22.06.2019 15:50

Select all the correct answers. which changes will increase the rate of reaction during combustion? decreasing the area of contact between the reactants adding more oxygen to the reaction removing heat from the reaction changing the reactants from solid form to powdered form lowering the exposure of the reactants to air

Answers: 3

Answer

Physics, 22.06.2019 21:30

Atoaster oven has a resistive heating element. the average rate at which it dissipates energy as thermal energy is 1.00 $\rm kw$. in the united states, emf amplitude in household circuits is $\mathcal e_{\max}$ = 170 ${\rm \; v}$ and the $\rm ac$ oscillation rate is 60 $\rm hz$. part a what is the root-mean-square current through the heating element?

Answers: 2

Answer

Physics, 22.06.2019 23:40

To place a communications satellite into a geosynchronous orbit at an altitude of 22,240 mi above the surface of the earth, the satellite first is released from a space shuttle , which is in a circular orbit at an altitude of 185 mi, and then is propelled by an upper-stage booster to its final altitude. as the satellite passes through a, the booster's motor is fired to insert the satellite into an elliptic transfer orbit. the booster is again fired at b to insert the satellite into a geosynchronous orbit. knowing that the second firing increases the speed of the satellite by 4810ft/s, determine (a.) the speed of the satellite as it approaches b on the elliptic transfer orbit, (b.) the increase in speed resulting from the first firing at a.

Answers: 2

Answer

Physics, 23.06.2019 07:00

Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater.what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?

Answers: 3

Answer

You know the right answer?

A bullet of mass 10 g strikes a ballistic pendulum of mass 2.0 kg. The center of mass of the pendulu...

Questions