subject
Physics, 21.01.2021 18:00 drainy0uandthefish

Which of the following situations describes a non-contact force acting on an object?


Which of the following situations describes a non-contact force acting on an object?

ansver
Answers: 1

Another question on Physics

question
Physics, 22.06.2019 11:00
1.)the isotope cobalt-60 has a nuclear mass of 59.933820 u calculate the mass defect of cobalt-60 using the following information. mass of proton: 1.007825 u mass of neutron: 1.008665 u 1 u = 931.5 mev 2.)the isotope cobalt-60 has a nuclear mass of 59.933820 u calculate the binding energy of cobalt-60 using the following information. mass of proton: 1.007825 u mass of neutron: 1.008665 u 1 u = 931.5 mev 3.)the isotope cobalt-60 has a nuclear mass of 59.933820 u calculate the binding energy per nucleon of cobalt-60 using the following information. mass of proton: 1.007825 u mass of neutron: 1.008665 u 1 u = 931.5 mev
Answers: 3
question
Physics, 22.06.2019 20:10
Atruck with 34-in.-diameter wheels is traveling at 55 mi/h. find the angular speed of the wheels in rad/min, *hint convert miles to inches & hours to minutes:
Answers: 2
question
Physics, 23.06.2019 04:40
2) a cubical block of stone is lowered at a steady rate into the ocean by a crane, always keeping the top and bottom faces horizontal. which one of the following graphs best describes the buoyant force b on this block as a function of time t if the block just enters the water at time t = 0 s?
Answers: 3
question
Physics, 23.06.2019 07:00
Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater.what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?
Answers: 3
You know the right answer?
Which of the following situations describes a non-contact force acting on an object?
...
Questions
question
Mathematics, 26.05.2021 20:50
question
Mathematics, 26.05.2021 20:50
question
Biology, 26.05.2021 20:50
question
Mathematics, 26.05.2021 20:50
question
World Languages, 26.05.2021 20:50
question
Mathematics, 26.05.2021 20:50
question
Mathematics, 26.05.2021 20:50
Questions on the website: 13722360