The mass of the nails and copper sulfate solution used in this investigation was 250g. The mass of the copper and iron sulfate solution produced in this investigation would be 250g. 1. less than
2. equal to
3. greater than

1. consider the case in which air fills air shocks on a truck trailer. the pressure in the shocks is 2 mpa. the temperature is 300 k. the diameter of the shock piston is 10 cm and the initial length of the cylindrical cavity containing the compressed air is 40 cm. a. the truck is gradually loaded over a period of a day in a static setting. the temperature is held constant for the atmosphere and thus for the gas shock. calculate the compressibility of the air in the shock for this condition when the truck is initially being loaded. b. if the shocks were loaded in a dynamic setting by driving over bumps, what would be the compressibility? state your assumption. c. what is the initial load on the shock if the shock is in an atmospheric 100 kpa? d. if the shock is compressed using the process described in part a, and the air shock compressed air cavity length decreases to 20 cm, what is the additional load applied to the shock?

•• al and bert are jogging side-by-side on a trail in the woods at a speed of 0.75 m/s. suddenly al sees the end of the trail 35 m ahead and decides to speed up to reach it. he accelerates at a constant rate of 0.50 m/s2, while bert continues on at a constant speed. (a) how long does it take al to reach the end of the trail? (b) once he reaches the end of the trail, he immediately turns around and heads back along the trail with a constant speed of 0.85 m/s. how long does it take him to meet up with bert? (c) how far are they from the end of the trail when they meet?

The precision of a laboratory instrument is ± 0.05 g. the accepted value for your measurement is 7.92 g. which measurements are in the accepted range? check all that apply. 7.85 g 7.89 g 7.91 g 7.97 g 7.99 g