Physics, 29.01.2020 07:52 Bryansbaby03

Mass m, moving at speed 2v, approaches mass 4m, moving at speed v. the two collide elastically head-on. part a find the subsequent speed of mass m.

Answers: 2

Show answers

Another question on Physics

Physics, 23.06.2019 02:50

You are your friend move a new refrigerator into his kitchen. you apply a horizontal force of 252 n in the negative x direction to try and move the 56 kg refrigerator. the coefficient of static friction is 0.61. (a) how much static frictional force does the floor exert on the refrigerator? give both magnitude (in n) and direction. magnitude n direction (b) what maximum force (in n) do you need to apply before the refrigerator starts to move?

Answers: 1

Answer

Physics, 23.06.2019 08:00

Use henry's law and the solubilities given below to calculate the total volume of nitrogen and oxygen gas that should bubble out of 1.7 l of water upon warming from 25 ˚c to 50 ˚c. assume that the water is initially saturated with nitrogen and oxygen gas at 25 ˚c and a total pressure of 1.0 atm. assume that the gas bubbles out at a temperature of 50 ˚c. the solubility of oxygen gas at 50 ˚c is 27.8 mg/l at an oxygen pressure of 1.00 atm. the solubility of nitrogen gas at 50 ˚c is 14.6 mg/l at a nitrogen pressure of 1.00 atm. assume that the air above the water contains an oxygen partial pressure of 0.21 atm and a nitrogen partial pressure of 0.78 atm.

Answers: 2

Answer

Physics, 23.06.2019 10:30

Auniform bridge, 20 m long and weighing 40000 n is supported by two pillars located 3.0 m from each end. if a 19600 n car is parked 8.0 m from one end of the bridge, how much force does each pillar exert?

Answers: 3

Answer

Physics, 23.06.2019 10:40

2.which choice most accurately explains what happens to the bonds between atoms when water changes to steam, and what becomes of the energy added during this phase change? when water changes to steam bonds between molecules are created. after reaching the boiling point, energy is used to change bond strength and change the kinetic energy of the atoms. when water changes to steam bonds between molecules break apart. after reaching the boiling point, energy is used to break bonds, but does not affect the kinetic energy of the atoms. when water changes to steam bonds between molecules are created. after reaching the boiling point, energy is used to break bonds, but does not affect the kinetic energy of the atoms. when water changes to steam bonds between molecules break apart. after reaching the boiling point, energy is used to change bond strength and change the kinetic energy of the atoms.

Answers: 1

Answer

You know the right answer?

Mass m, moving at speed 2v, approaches mass 4m, moving at speed v. the two collide elastically head-...

Questions