It takes Serina 0.25 hours to drive to school. Her route is 16 km long. What is Serina’s average speed on her drive to school? pls show equation

17.78 m/s

Explanation:

Average speed is found by simply dividing the distance travelled by the time that it took to finish the trip. It's measured in meters per second (m/s), so first convert the quantities.

1 km = 1000 m, so 16 km is 16000 m

0.25 hours is 15 minutes. Since 1 minute is 60 seconds, then 15 minutes must be 900 seconds.

Thus:

average speed = total distance/total time = 16000 m / 900 s = 17.78 m/s

Hope this helps!

Brainliest please!

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

answer: decibel

explanation: