How would the model change as the atom forms bonds? The third shell would have eight electrons after the atom gains seven electrons to fill the outermost shell. The third shell would be empty so that the eight electrons in the second level would be outermost after the atom loses one electron. The first and third shells would be empty so that the atom would have eight electrons in its remaining shell after the atom loses three electrons. The first shell would have two electrons and the second shell would have six electrons after the atom loses three electrons.

The third shell would be empty, so the eight electrons on the second level would be the outermost after the atom lost one electron

Explanation:

When an atom is bonded with other atoms, a more stable configuration must be reached, which is why the energy of the molecule is less than the energy of the individual atoms, for this to happen in general, electrons are shared or lost and gained in each atom, depending on the electronegative of the same.

If we analyze an atom within the molecule, its last shell is full, in the case of atoms with few electrons in this shell, they are lost and in the case of many electors in this shell, it gains electrons to have eight (8) in total.

When reviewing the different answers, the correct one is:

* The third shell would be empty, so the eight electrons on the second level would be the outermost after the atom lost one electron

It’s B

Explanation:

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

a coal burning power plant