First record some data for this comparison in the table below. •Record your measured values of displacement and velocity for times t=8.0 seconds and t=10.0 seconds in the columns below.
• Next use the measured displacement and velocity values at t=7.0 seconds and t=9.0 seconds to interpolate the values of displacement and velocity at t=8.0 seconds.
• use the following formula to interpolate and extrapolate. Remember, x and y here represent values on the x and y axes of the graph. The x values will really be time and the y values will be either displacement(x) or velocity (vx)
y-y0=[(y1-y0)/ (x1-x0)] •(x-x0)

A1kg cart slams into a stationary 1kg cart at 2 m/s. the carts stick together and move forward at a speed of 1 m/sl. determine whether kinetic energy was conserved in the collision. use the law of conservation of energy to explain the collision

Steam is generated in a boiler of a cogeneration plant at 10 mpa and 450°c at a steady rate of 5 kg/s. in normal operation, steam expands in a turbine to a pressure of 0.5 mpa and is then routed to the process heater, where it supplies the process heat. steam leaves the process heater as a saturated liquid and is pumped to the boiler pressure. in this mode, no steam passes through a condenser, which operates at 20 kpa. (a) determine the power produced in the turbine and the rate at which process heat is supplied in this mode. (b) determine the power produced in the turbine and the rate of process heat supplied if only 60 percent of the steam is routed to the process heater and the remainder is expanded to the condenser pressure. (3.32 mw; 9.69 mw; 4.25 mw; 5.82 mw)

Antireflective coatings on solar cells are often made by applying a thin film of silicon nitride (sinx), which has an index of refractive of 1.2, on the top of the silicon solar cell, which has a refractive index of about 3.5. however, the sun emits radiation of various wavelengths which the solar cell absorbs, and the antireflective coating can only absolutely minimize the reflection of one of these wavelengths. the coating thickness is chosen to reduce the reflection of green/yellow light (e = 2.2 ev), which is the most intense color in the solar spectrum (shown below). which of the following coatings would minimize reflection of green/yellow light? the answer is 820 nm how? what is the angular width of the central maximum of an electron traveling at 2 x 108 m/s going through a single slit of width 1 mm.