Date Pd
Practice Representing Systems and Change
For each of the following problems, choose your system so that energy is conserved but do not place
anything in the system other than those elements which are essential to include energy conservation.
a. Specify the system, then draw a system schema.
b. Add a written description of the changes represented.
c. Construct Energy Bar Charts for the initial and final states of your system. Be sure to label the
“L's” in your charts and complete the energy-flow diagram
1. A student lifts some books from the bottom of his locker.
a. System Schema:

Ablock of steel has a density of 0.29lbs per cubic inch. if the block has dimensions of 1 inch by 1 inch by 3 inches, what is its weight? a. 0.29lbs b. 0.58lbs c. 0.87lbs d. 1lbs

Calculate the ratio of h+ ions to oh– ions at a ph = 6. find the concentration of h+ ions to oh– ions listed in table b of your student guide. then divide the h+ concentration by the oh– concentration. record this calculated ratio in table a of your student guide. compare your approximated and calculated ratios of h+ ions to oh– ions at a ph = 6. are they the same? why or why not? record your explanation in table a. what is the concentration of h+ ions at a ph = 6? mol/l what is the concentration of oh– ions at a ph = 6? mol/l what is the ratio of h+ ions to oh– ions at a ph = 6? : 1

Antireflective coatings on solar cells are often made by applying a thin film of silicon nitride (sinx), which has an index of refractive of 1.2, on the top of the silicon solar cell, which has a refractive index of about 3.5. however, the sun emits radiation of various wavelengths which the solar cell absorbs, and the antireflective coating can only absolutely minimize the reflection of one of these wavelengths. the coating thickness is chosen to reduce the reflection of green/yellow light (e = 2.2 ev), which is the most intense color in the solar spectrum (shown below). which of the following coatings would minimize reflection of green/yellow light? the answer is 820 nm how? what is the angular width of the central maximum of an electron traveling at 2 x 108 m/s going through a single slit of width 1 mm.