subject
Physics, 11.02.2021 18:30 FutureDB

Please help me please I need someone to help me with all this question 1) How do we calculate the momentum of a race car? What part of this changes during a collision? 2) What happening to the momentum of the car when they crash? 3) how does impulse factor into this? 4) what type of collision is it ( ideally) when cars crash into this SAFER barrier?

ansver
Answers: 3

Another question on Physics

question
Physics, 22.06.2019 18:10
Arefrigerator uses r-134a as the working fluid and operates on the ideal vapor-compression refrigeration cycle except for the compression process. the refrigerant enters the evaporator at 120 kpa with a quality of 34 percent and leaves the compressor at 70°c. if the compressor consumes 450 w of power, determine (a) the mass flow rate of the refrigerant, (b) the condenser pressure, and (c) the cop of the refrigerator. (0.00644 kg/s, 800 kpa, 2.03)
Answers: 1
question
Physics, 22.06.2019 20:10
Two cannon balls weighing 18 kg and 24 kg are chained together and fired horizontally with a velocity of 165 m/s from the top of a 21-m wall. the chain breaks during the flight of the cannonballs and the 18-kg cannonball strikes the ground at t = 1.5 s, at a distance of 240 m from the foot of the wall, and 7 m to the right of the line of fire. determine the position of the other cannonball at that instant. neglect the resistance of the air.
Answers: 1
question
Physics, 23.06.2019 07:00
Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater.what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?
Answers: 3
question
Physics, 23.06.2019 08:30
Apoint charge +q is at the origin. a spherical gaussian surface centered at the origin encloses +q. so does a cubical surface centered at the origin and with edges parallel to the axes. select "true" or "false" for each statement below. the electric flux through the spherical surface is greater than that through the cubical surface. suppose (for this statement only), that q is moved from the origin but is still within both the surfaces. the flux through both surfaces remains unchanged. the area vector and the e-field vector point in the same direction for all points on the spherical surface. the e-field at all points on the spherical surface is equal due to spherical symmetry. the flux through the spherical gaussian surface is independent of its radius.
Answers: 3
You know the right answer?
Please help me please I need someone to help me with all this question 1) How do we calculate the mo...
Questions
question
Mathematics, 16.04.2020 22:07
Questions on the website: 13722359