subject
Physics, 20.02.2021 06:20 colebash88

An engineer is designing the runway for a new airport. The lowest acceleration rate of the plane's that will use the airport is likely to
be 3.0 m/s2. The takeoff speed for that plane is 65 m/s. What is
the minimum runway length needed for this plane to successfully
takeoff?

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 21:50
When applying kirchhoff's rules, one of the essential steps is to mark each resistor with plus and minus signs to label how the electric potential changes from one end of the resistor to the other. the circuit in the drawing contains four resistors, each marked with the associated plus and minus signs. however, one resistor is marked incorrectly. which one is it?
Answers: 1
question
Physics, 22.06.2019 05:30
The a992 steel rod bc has a diameter of 50 mm and is used as a strut to support the beam. determine the maximum intensity w of the uniform distributed load that can be applied to the beam without risk of causing the strut to buckle. take f.s. = 2 against bucklin
Answers: 3
question
Physics, 22.06.2019 05:30
Choose the most likely outcome of this scenario: jen decided to go bike riding without a helmet. while no one is around during her ride, she is thrown from her bike when her wheel goes into a pothole. she is not injured, but she is terrified to get back on her bike. what happens next? a. her physical health is affected even though she wasn't hurt. b. her mental and emotional health are affected because she is afraid to get back on her bike. c. her social health is affected because she is worried her friends saw the fall. d. her overall health is not affected at all by her fall.
Answers: 1
question
Physics, 22.06.2019 12:00
Asolid round steel rod 6.25 mm in diameter and 375 mm long is rigidly bonded to the end of solid square brass rod 25 mm on a side and 300 mm long. the geometric axes of the bare are along the same line. an axial tensile force of 5.4 kn is applied at the extreme ends of the assembly. for steel e = 200 gpa and for brass e = 90 gpa. determine the total elongation for the assembly.
Answers: 1
You know the right answer?
An engineer is designing the runway for a new airport. The lowest acceleration rate of the plane's...
Questions
question
Mathematics, 17.02.2020 04:54
question
Mathematics, 17.02.2020 04:55
question
Arts, 17.02.2020 05:12
Questions on the website: 13722359