C) The manufacturer claims the drill motor has an efficiency of 0.35. The drill motor is supplied with 3000 J of electrical energy when the hole is drilled. Calculate: (4 marks) i) The useful energy from the drill motor.

ii) The energy wasted by the drill.

i would think form in reponse to tensional forces

spectral lines lyman is one set

so here is the information for current research:

-nrel's geothermal analysts, scientists, and engineers perform a full range of research from developing advanced methods of locating and accessing geothermal resources to exploring innovative technologies to extract and produce clean energy from the heat of the earth

and here is the information for the technology of geothermal energy:

-it's clean and sustainable

-resources of geothermal energy range from the shallow ground to hot water and hot rock found a few miles beneath the earth's surface, and down even deeper to the extremely high temperatures of molten rock called magma

-almost everywhere, the shallow ground or upper 10 feet of the earth's surface maintains a nearly constant temperature between 50° and 60°f (10° and 16°c)

-geothermal heat pumps can tap into this resource to heat and cool buildings

-a geothermal heat pump system consists of a heat pump, an air delivery system (ductwork), and a heat exchanger-a system of pipes buried in the shallow ground near the building

-in the winter, the heat pump removes heat from the heat exchanger and pumps it into the indoor air delivery system

-in the summer, the process is reversed, and the heat pump moves heat from the indoor air into the heat exchanger

-the heat removed from the indoor air during the summer can also be used to provide a free source of hot water

  distance on the y-axis and time on the x-axis.

explanation:

the instantaneous velocity = change in position/time taken

the slope of the graph should give instantaneous velocity.

  slope of a graph = change in value of y -axis / change in values of x -axis

  comparing both the equations

    change in value of y -axis = change in position

  change in values of x -axis = time taken

so position values should be on the y axis and time values should be on the x axis.

distance on the y-axis and time on the x-axis.