A 4-watt night light is plugged into a 120-volt circuit and operates continuously for a 30-day
month.
a. How much current does it draw?
b. What is the resistance of its filament?
c. How much energy does it use in the month?
d. What is the cost of its operation for the
month at the utility rate of 10 cents per
Kilowatt-hour?

Two horizontal plates with infinite length and width are separated by a distance h in the z direction. the bottom plate is moving at a velocity u. the incompressible fluid trapped between the plates is moving in the positive x-direction with the bottom plate. align gravity with positive z. assume that the flow is fully-developed and laminar. if the systems operates at steady state and the pressure gradient in x-direction can be ignored, do the following: 1. sketch your system 2. identify the coordinate system to be used. 3. show your coordinates and origin point on the sketch. list all your assumptions. 5. apply the continuity equation to your system. nts of navier stokes equations of choice to your system 7. solve the resulting differential equation to obtain the velocity profile within the system make sure to list your boundary conditions. check units of velocity 8. describe the velocity profile you obtain using engineering terminology. sketch that on the same sketch you provided in (1). 9. obtain the equation that describes the volumetric flow rate in the system. check the units.

You are traveling in a car going at a constant speed of 100km/h down a long, straight highway. you pass another car going in the same direction which is traveling at a constant speed of 80km/h. as measured from your car's reference frame this other car is traveling at −20km/h. what is the acceleration of your car as measured from the other car's reference frame? what is the acceleration of the other car as measured from your car's reference frame?

Which of the following changes will increase the capacitance of a parallel-plate capacitor? (there could be more than one correct choice.) a) increase the charge on the plates b) decrease the poten5al between the plates c) increase the potential between the plates d) introduce a dielectric material between the plates e) decrease the separation between the plates