Physics, 22.03.2021 23:40 issagershome

Please answer either or both of these questions! I will pick brainiest! Please give an actual answer :) Thanks! 1. What is the resistance of a lamp that is connected to a 110 voltage source that draws 2 amps of
current?
2. The resistance of an electric stove burner element is 11 ohms. What current flows through this
element when it runs off a 220 volt line?

Answers: 2

Show answers

Another question on Physics

Physics, 22.06.2019 10:30

Agroup of students were investigating the force of gravity. they began by dropping a foam ball from a height of 3 meters into a bucket of sand. the ball hit the sand in 0.306 seconds. they dropped additional balls of approximately the same diameter, but of different masses. here is the data they collected. based on this experiment and the collected data, what would their conclusion be?

Answers: 1

Answer

Physics, 22.06.2019 11:00

I'm thinking it's 2 you are asked to explain the earth's magnetic field. which is the best reply? 1. the earth's magnetic south is similar to the north pole of a magnet. 2. the earth's core has a strong magnetic charge similar to the south pole of a magnet. 3. the earth's geomagnetic south is similar to the south pole of a magnet. 4. the earth's magnetic charge is not centered at either pole; it varies based on location.

Answers: 1

Answer

Physics, 22.06.2019 20:00

Aturntable that spins at a constant 74.0 rpm takes 3.10 s to reach this angular speed after it is turned on. find its angular acceleration (in rad/s2), assuming it to be constant, and the number of degrees it turns through while speeding up.

Answers: 2

Answer

Physics, 22.06.2019 21:20

Abeverage can is made of 3004-h19 aluminum alloy (elastic modulus 69 gpa, tensile yield strength 285 mpa, density 2.72 g/cm^3). the dimensions on the can are approximated as a thin-walled cylinder with a height of 4.83 inches, diameter of 2.60 inches. empty the can has a mass of 14.2 g. determine: a. the wall thickness of the cylinder b. assuming a pinned-pinned condition what is the critical load? c. assuming a fixed-fixed condition what is the critical load?

Answers: 1

Answer

You know the right answer?

Please answer either or both of these questions! I will pick brainiest! Please give an actual answer...

Questions