Physics, 23.03.2021 01:40 andrewjsoto

DENSITY OF SOLIDS Section III: Analysis and Discussion
Use your answers from questions 6–8 as the basis for the third section of your lab report. This section provides your reader with your interpretation of the data set. You will also give an example of any calculations or formulas you used to analyze your data. Also, if you want to include any graphs that you made and interpret them for the reader, you can.
If you do construct graphs, your Student Guide includes information on which graphs to construct. Graphs should have the following:

Appropriate titles
Appropriate labels for each axis
Appropriate scales for each axis
Correct units for the data

Complete a rough sketch of each graph. Explain in one or two sentences what trend the reader should observe in each of your graphs.
Mention any problems, unusual or unexpected data, or other factors with the experiment here, and suggest possible causes. This section can be somewhat subjective, unlike Section II, because you are free to include your personal interpretations or even speculation if it adds constructive, reasonable insight to the discussion.

Answers: 1

Show answers

Another question on Physics

Physics, 21.06.2019 17:20

If the force on an object is in the negative direction, the work it does on the object must be [2 points a) negative. b) positive c) the work could be either positive or negative, depending on the direction the object moves

Answers: 1

Answer

Physics, 22.06.2019 05:20

Very large accelerations can injure the body, especially if they last for a considerable length of time. one model used to gauge the likelihood of injury is the severity index ( ), defined as =/ . in the expression, is the duration of the accleration, but is not equal to the acceleration. rather, is a dimensionless constant that = the number of multiples of that the acceleration is equal to.in one set of studies of rear-end collisions, a person's velocity increases by 13.7 km/h with an acceleration of 36.0 m/s2 . let the + direction point in the direction the car is traveling. what is the severity index for the collision?

Answers: 1

Answer

Physics, 22.06.2019 09:40

Asatellite component is in the shape of a cube with 10cm edges, has an evenly distributed mass of 2 kg and one bolt hole at each of four corners. if the maximum predicted random vibration environment is 10 grms, what bolt size would be a good choice for restraint? what other factors might drive bolt size besides force/stress?

Answers: 2

Answer

Physics, 22.06.2019 10:30

An insulated 40 ft^3 rigid tank contains air at 50 psia and 120°f. a valve connected to the tank is now opened, and air is allowed to escape until the pressure inside drops to 25 psia. the air temperature during this process is kept constant by an electric resistance heater placed in the tank. determine the electrical work done during this process.

Answers: 2

Answer

You know the right answer?

DENSITY OF SOLIDS Section III: Analysis and Discussion
Use your answers from questions 6–8 as...

Questions