Physics, 23.03.2021 14:00 xxaurorabluexx
A 10 V battery is connected to a voltage divider circuit
which consists of a 100 Ω resistor and a 300 Ω resistor.
a What is the voltage across the 300 Ω resistor?
A 2.5 V
B 3.3 V
C 7.5 V
D 13.3 V
b) What is the voltage drop across the 100 Ω resistor?
A 2.5 V
B 3.3 V
C 7.5 V
D 13.3 V
Answers: 3
Physics, 22.06.2019 12:30
An object resting on a table weighs 100 n. with what force is the object pushing on the table? with what force is the table pushing on the object? explain how you got your answer.
Answers: 2
Physics, 22.06.2019 20:30
Light from two different sources are incident upon the same side of a polarizing filter. light from one source is polarized with total intensity ip, while light from the other source is unpolarized with total intensity iu. as you rotate the polarizing filter through 360 degrees, the intensity of the transmitted light on the other side varies by a factor of 9. what is the relative intensity of the initial polarized source to the unpolarized source, or ip/iu?
Answers: 2
Physics, 23.06.2019 08:30
Industrial processes often require the damping of vibrations. consider a workbench that uses four large ideal springs in place of traditional legs, with each spring supporting one corner of the workbench and exhibiting a force constant of 47500 n/m. this workbench is used when creating products that involve highly unstable chemicals. according to specifications, the acceleration of the manufacturing equipment must be held to less than 22.3 m/s2 for the manufacturing process to proceed safely. the amplitude of vibrations are expected to remain under 0.622 mm throughout. given that the workbench and maufacturing equipment combine to 6.05 kg, find the maximum acceleration expected of the equipment and workbench. (ignore the mass of the springs.)
Answers: 2
Physics, 23.06.2019 13:30
The goal of this experiment was to answer the question, "how does diffraction occur? " suppose you formulated this alternate hypothesis: if the gap width is increased while keeping wavelength constant, then the observed diffraction will decrease because the less the ratio between wavelength and gap width is, the smaller the observed diffraction angle will be.to test this hypothesis, you would change the gap widthdiffraction anglewavelength and observe the gap widthdiffraction anglewavelength in the system.therefore, the independent variable would be the gap widthdiffraction anglewavelength and the dependent variable would be the gap widthdiffraction anglewavelength.
Answers: 1
A 10 V battery is connected to a voltage divider circuit
which consists of a 100 Ω resistor and a 3...
Physics, 20.08.2019 23:30
Mathematics, 20.08.2019 23:30
Social Studies, 20.08.2019 23:30
History, 20.08.2019 23:30
Social Studies, 20.08.2019 23:30
Social Studies, 20.08.2019 23:30
Mathematics, 20.08.2019 23:30
Mathematics, 20.08.2019 23:30
Biology, 20.08.2019 23:30