Two frictionless carts are on a horizontal track. The first cart is initially at rest, and has a mass of 0.500 kg. It has a massless spring for a bumper (with spring constant 400 N/m). The second cart (mass of 0.800 kg), heads towards it from the left with a velocity of 2.00 m/s. a) What speed do the two carts have when they are travelling at the same speed

given data:

determine the horse power (h.p) = ?

force applied to move the box(f) = 10 pounds,

box lifted from a distance         (d) = 3 feet

time taken to lift                         (t) = 10 sec,

the horse power is defined as amount of work required to move a load. the horse power is equal to 550 foot-pound per second

                  1 h.p   = 550 foot-pound/second

it can also be defined as the the load that need to be move a body for certain distance in a certain amount of time.

mathematically,

                      h.p = (force × distance)/ time

                            = (10 × 3)/ 10

                            = 30/10

                            = 3 foot -pound/sec

hence, the horse power is needed to move the box is 3 foot-pound/second

important note: 1 h.p = 550 foot-pound/second = 746 watts

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).