Physics, 13.04.2021 22:30 ashneedshelp1251

A 400 12
b
290 22
The question below refers to the circuit shown in the image
12.0 V
Which of the following statements is NOT true regarding the circuit?
O Adding another resistor in series would decrease the current through the battery
The 400 Q resistor has a smaller current than the 290 Q resistor
o Increasing the voltage of the battery would increase the current through each resistor
The 400 Q resistor will use more of the voltage provided by the battery

A

400 12
b
290 22
The question below refers to the circuit shown in the image
12.0 V
Which of the

Answers: 3

Show answers

Another question on Physics

Physics, 21.06.2019 15:00

If this plastic cup is heated to its melting point, what will eventually happen to all the particles in the plastic? a. the particles will begin to move enough that they slide past each other. b. bonds will form and the liquid will become a solid. c. the spaces between the particles will get smaller. d. the particles will change state and become a crystalline solid.

Answers: 2

Answer

Physics, 21.06.2019 23:00

The key to stability is feedback between the reservoir and the fluxes into and/or out of the reservoir. assume that the rate of outflow from a reservoir depends on the size of the reservoir according to the following relationship: outflow rate= k x (size of reservoir), where k is a constant. a reservoir of water has a volume of 5000 liters, and the rate of outflow at steady state is 25 liters per minute. what is k? (give both the numerical value and its units.) what is the residence time? what is the relationship between k and the residence time?

Answers: 1

Answer

Physics, 22.06.2019 10:00

How are the crust and the inner core alike? a) they are both solid. b) they both have the same temperature. c) they are both under the same pressure. d) they are both very close to the center of the earth.

Answers: 1

Answer

Physics, 22.06.2019 10:40

As you are trying to move a heavy box of mass m, you realize that it is too heavy for you to lift by yourself. there is no one around to , so you attach an ideal pulley to the box and a massless rope to the ceiling, which you wrap around the pulley. you pull up on the rope to lift the box. use g for the magnitude of the acceleration due to gravity and neglect friction forces. once you have pulled hard enough to start the box moving upward, what is the magnitude f of the upward force you must apply to the rope to start raising the box with constant velocity? express the magnitude of the force in terms of m, the mass of the box.

Answers: 1

Answer

You know the right answer?

A 400 12
b
290 22
The question below refers to the circuit shown in the image

Questions