Physics, 30.01.2020 19:00 HotWheels162000

Which of the following objects has the most kinetic energy?

a car going 60 miles per hour
a spring that is compressed
a rock sitting on the edge of a cliff
a bicycle going 10 miles per hour

Answers: 3

Show answers

Another question on Physics

Physics, 22.06.2019 02:30

Which of the following are properties of mechanical waves? check all that apply ⭕️ particles of the medium move back and fourth, but do not move with the wave. ⭕️ the particles of the medium always move parallel to the wave motion. ⭕️ wave motion begins with a disturbance in the medium. ⭕️ waves transport energy from a source outward, away from the source.

Answers: 2

Answer

Physics, 22.06.2019 14:20

A1-lb collar is attached to a spring and slides without friction along a circular rod in a vertical plane. the spring has an undeformed length of 5 in. and a constant k =25 lb/ft. knowing that the collar is released from being held at a determine, the speed of the collar and the normal force between the collar and the rod as the collar passes through b.

Answers: 3

Answer

Physics, 22.06.2019 19:40

22. the top of a cliff is located a distance h above the ground. at a distance h/2 there is a branch that juts out from the side of the cliff, and on this branch a bird's nest is located. two children throw stones at the nest with the same initial speed, one stone straight downward from the top of the cliff and the other stone straight upward from the ground. in the absence of air resistance, which stone hits the nest in the least amount of time?

Answers: 1

Answer

Physics, 23.06.2019 07:00

Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater.what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?

Answers: 3

Answer

You know the right answer?

Which of the following objects has the most kinetic energy?

a car going 60 miles per ho...

Questions