Which of the following is most likely to happen when a plate carrying oceanic crust collides with a plate carrying continental crust?
a. the denser oceanic plate gradually sinks into the mantle and melts.
b. the less dense continental plate gradually sinks into the mantle and melts.
c. both the oceanic and the continental plates sink into the mantle and melt.
d. the plates collide and mantle convection stops.

i need the answer asap !

Note: the following questions are unrelated to the balmer series or the martian. refer to your course notes. a sun-sized star will spend most of its lifetime as a: white dwarf b. red giant c. protostar d. main-sequence star

First, launch the video below. you will be asked to use your knowledge of physics to predict the outcome of an experiment. then, close the video window and answer the question at right. you can watch the video again at any point. part a as in the video, we apply a charge +q to the half-shell that carries the electroscope. this time, we also apply a charge –q to the other half-shell. when we bring the two halves together, we observe that the electroscope discharges, just as in the video. what does the electroscope needle do when you separate the two half-shells again? view available hint(s) as in the video, we apply a charge + to the half-shell that carries the electroscope. this time, we also apply a charge – to the other half-shell. when we bring the two halves together, we observe that the electroscope discharges, just as in the video. what does the electroscope needle do when you separate the two half-shells again? it deflects more than it did at the end of the video. it deflects the same amount as at end of the video. it does not deflect at all. it deflects less than it did at the end of the video. submit

Agas contained within a piston-cylinder assembly undergoes three processes in series: process 12: compression with pv= constant from 1 bar and 1 liter to 4 bar. process 23: constant pressure expansion to 1 liter. process 31: constant volume calculate the pressure and volume at each state, and sketch the processes on a p-vdiagram labeled with pressure and volume values at each numbered stat