Physics, 31.08.2019 13:30 woodb2192

Technician a says that the oil control ring scrapes oil off the cylinder wall with each downward piston stroke. technician b says that a typical oil control ring consists of two separate pieces. who is right? a. neither technician a nor b b. both technicians a and b c. technician b only d. technician a only
for penn foster..

Answers: 2

Show answers

Another question on Physics

Physics, 21.06.2019 22:40

Ablock of mass m = 2.5 kg is attached to a spring with spring constant k = 710 n/m. it is initially at rest on an inclined plane that is at an angle of θ = 23° with respect to the horizontal, and the coefficient of kinetic friction between the block and the plane is μk = 0.19. in the initial position, where the spring is compressed by a distance of d = 0.16 m, the mass is at its lowest position and the spring is compressed the maximum amount. take the initial gravitational energy of the block as zero. a) what is the block's initial mechanical energy? b) if the spring pushes the block up the incline, what distance, l, in meters will the block travel before coming to rest? the spring remains attached to both the block and the fixed wall throughout its motion.

Answers: 3

Answer

Physics, 22.06.2019 05:30

What are similarities and differences of reflection, refraction, diffraction and absorption?

Answers: 1

Answer

Physics, 22.06.2019 06:30

5submission this assignment is worth 20 points total. you are required to submit the following by next lab: 1. (3 points) determine the equation for the output angular velocity ω2 = θ˙ 2 as a function of θ1, ω1 = θ˙ 1 and α. you must show all your work to receive credit. 2. (2 points) use the result of problem#1 to plot ω2 over 0 ≤ θ1 ≤ 360deg with ω1 = 360deg/sec. do this for α = {10,30}deg. show the results on the same plot and properly label the axes, title, legend. for this you can use matlab or ms excel. 3. (3 points) determine the equation for the output angular acceleration ω˙ 2 and create a plot similar to the one in problem#2. 4. (10 points) submit plots of the results (ω2 and ω˙ 2) obtained from creo/mechanism and compare them to results of problem#2 and problem#3. note that you should do these comparisons for the two cases with α = {10,30}deg. 5. (2 points) provide a brief explanation of the results. did they match? what are the implications as misalignment angle increases?

Answers: 3

Answer

Physics, 22.06.2019 14:30

When is a current produced? when the terminals of an electrochemical cell are connected by a wire if the electric circuit is opened in an electrochemical cell if the electrolyte is removed from an electrochemical cell when the electrodes are reversed in an electrochemical cell

Answers: 2

Answer

You know the right answer?

Technician a says that the oil control ring scrapes oil off the cylinder wall with each downward pis...

Questions