Physics, 28.10.2019 14:31 CDMJ8320

For the circuit shown in the figure above, the correct procedure for measuring the resistance value of r1 is to

a. connect the multimeter between points d and a and measure the resistance with switch s1 open.
b. connect the multimeter between points c and d and measure the resistance with switch s1 open.
c. connect the multimeter between points c and d and measure the resistance with switch s1 closed.
d. connect the multimeter between points d and a and measure the resistance with switch s1 closed.

Answers: 2

Show answers

Another question on Physics

Physics, 21.06.2019 18:00

Which of the following changes to a pipe would increase the conductance by a factor of 12? 1.quadrupling the length and tripling the radius.2.reducing the length by a factor of and doubling the radius.3.tripling the length and reducing the radius by a factor of .4.reducing the length but a factor of and doubling the radius.

Answers: 3

Answer

Physics, 22.06.2019 15:10

Auniform crate c with mass mc is being transported to the left by a forklift with a constant speed v1. what is the magnitude of the angular momentum of the crate about point a, that is, the point of contact between the front tire of the forklift and the ground

Answers: 3

Answer

Physics, 22.06.2019 19:30

Water is siphoned from a large tank and discharges into the atmosphere through a 50-mm diameter tube. the end of the tube is b = 2.6 m below the tank bottom which is a = 6.7 m deep, and viscous effects are negligible. determine the maximum height h over which the water can be siphoned without cavitation occurring. atmospheric pressure is 101.4 kpa, and the water vapor pressure is 1.79 kpa (absolute). report your answer in meters to two decimal places.

Answers: 1

Answer

Physics, 23.06.2019 08:30

Ajogger runs 5.0 km on a straight trail

Answers: 1

Answer

You know the right answer?

For the circuit shown in the figure above, the correct procedure for measuring the resistance value...

Questions