When a driver brakes an automobile, friction between the brake disks and the brake pads converts part of the car’s kinetic energy to internal energy. If a 1500 kg automobile traveling at 32 m/s comes to a halt after its brakes are applied, how much can the temperature rise in each of the four 3.5 kg steel brake disks? Assume the disks are made of iron (c = 448 J/kg•°C) and that all of the kinetic energy is distributed in equal parts to the internal energy of the brakes.

Steam is generated in a boiler of a cogeneration plant at 10 mpa and 450°c at a steady rate of 5 kg/s. in normal operation, steam expands in a turbine to a pressure of 0.5 mpa and is then routed to the process heater, where it supplies the process heat. steam leaves the process heater as a saturated liquid and is pumped to the boiler pressure. in this mode, no steam passes through a condenser, which operates at 20 kpa. (a) determine the power produced in the turbine and the rate at which process heat is supplied in this mode. (b) determine the power produced in the turbine and the rate of process heat supplied if only 60 percent of the steam is routed to the process heater and the remainder is expanded to the condenser pressure. (3.32 mw; 9.69 mw; 4.25 mw; 5.82 mw)

Some material consisting of a collection of microscopic objects is kept at a high temperature. a photon detector capable of detecting photon energies from infrared through ultraviolet observes photons emitted with energies of 0.3 ev, 0.5 ev, 0.8 ev, 2.0ev, 2.5ev, and 2.8ev. these are the only photon energies observed. (a) draw and label a possible energy-level diagram for one of the microscopic objects, which has four bound states. on the diagram, indicate the transitions corresponding to the emitted photons. explain briefly. (b) would a spring–mass model be a good model for these microscopic objects? why or why not? (c) the material is now cooled down to a very low temperature, and the photon detector stops detecting photon emissions. next, a beam of light with a continuous range of energies from infrared through ultraviolet shines on the material, and the photon detector observes the beam of light after it passes through the material. what photon energies in this beam of light are observed to be significantly reduced in intensity (“dark absorption lines”)? explain briefly.

Agroup of students were investigating the force of gravity. they began by dropping a foam ball from a height of 3 meters into a bucket of sand. the ball hit the sand in 0.306 seconds. they dropped additional balls of approximately the same diameter, but of different masses. here is the data they collected. based on this experiment and the collected data, what would their conclusion be?