Physics, 27.04.2021 08:20 teamsadie8426

3. Jose and Luke raced as they climbed to the top of the bleachers. Jose reached the top in 12.6 s and Luke reached the top in 13.3 s. Jose and Luke have the same mass,
Who did more work?
How do you know?
Who had more power?
How do you know?

Answers: 2

Show answers

Another question on Physics

Physics, 22.06.2019 00:30

In positive numbers less than 1, the zeros between the decimal point and non zero are significant

Answers: 2

Answer

Physics, 22.06.2019 23:00

Acommon technique in analysis of scientific data is normalization. the purpose of normalizing data is to eliminate irrelevant constants that can obscure the salient features of the data. the goal of this experiment is to test the hypothesis that the flux of light decreases as the square of the distance from the source. in this case, the absolute value of the voltage measured by the photometer is irrelevant; only the relative value conveys useful information. suppose that in part 2.2.2 of the experiment, students obtain a signal value of 162 mv at a distance of 4 cm and a value of 86 mv at a distance of 5.7 cm. normalize the students' data to the value obtained at 4 cm. (divide the signal value by 162.) then calculate the theoretically expected (normalized) value at 5.7 cm.

Answers: 2

Answer

Physics, 23.06.2019 02:30

Intro: a solid ball of radius rb has a uniform charge density ρ. part a: what is the magnitude of the electric field e(r) at a distance r> rb from the center of the ball? express your answer in terms of ρ, rb, r, and ϵ0. part b: what is the magnitude of the electric field e(r) at a distance r express your answer in terms of ρ, rb, r, and ϵ0. part c: let e(r) represent the electric field due to the charged ball throughout all of space. which of the following statements about the electric field are true? check all that apply. e(0) = 0 e(rb)=0 limr→∞e(r)=0 the maximum electric field occurs when r=0 the maximum electric field occurs when r=rb the maximum electric field occurs as r→∞.

Answers: 1

Answer

Physics, 23.06.2019 07:00

Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater.what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?

Answers: 3

Answer

You know the right answer?

3. Jose and Luke raced as they climbed to the top of the bleachers. Jose reached the top in 12.6 s a...

Questions