subject
Physics, 29.04.2021 17:20 tttyson

An ore cart of mass 1200 kg is rolling at a speed of 10.8 m/s across a flat surface. A crane dumps ore into the cart from directly above it, after which the cart travels at 9.3 m/s. Whet mass of ore did the armed to the cart? Assume that frictional forces with the flat surface are negligible.
190 kg
92 kg
110 kg
240 kg

ansver
Answers: 3

Another question on Physics

question
Physics, 22.06.2019 00:30
Imagine you work as a consultant, and your daily job involves listening to the constructive criticism of others. as part of your job, you must listen to opposing viewpoints to make important decisions. in this activity, you are a consulting dam engineer. you must make a decision about four different dams; should they be repaired, taken down, or left alone? you will listen to contrasting opinions about what should be done with the dams before you make the final decision. as the consulting dam engineer, what do you decide to do with this dam? explain your reasoning. by making your decision, did you support the opinions of the mayor and/or the dam safety official? why or why not? (site 1)
Answers: 1
question
Physics, 22.06.2019 10:30
The freezing and boiling point of a substance changes as the air pressure around it changes. for example, at a lower air pressure (higher altitude) it is easier for water molecules to escape from liquid into the air. in a high altitude city such as denver, colorado compared to a sea-level city such as houston, texas, water
Answers: 2
question
Physics, 22.06.2019 12:00
You have a resistor and a capacitor of unknown values. first, you charge the capacitor and discharge it through the resistor. by monitoring the capacitor voltage on an oscilloscope, you see that the voltage decays to half its initial value in 2.70 miss . you then use the resistor and capacitor to make a low-pass filter. what is the crossover frequency fc?
Answers: 2
question
Physics, 22.06.2019 15:30
At 20∘c, the hole in an aluminum ring is 2.800 cm in diameter. you need to slip this ring over a steel shaft that has a room-temperature diameter of 2.804 cm . 1. to what common temperature should the ring and the shaft be heated so that the ring will just fit onto the shaft? coefficients of linear thermal expansion of steel and aluminum are 12×10−6 k−1 and23×10−6 k−1 respectively.
Answers: 1
You know the right answer?
An ore cart of mass 1200 kg is rolling at a speed of 10.8 m/s across a flat surface. A crane dumps o...
Questions
Questions on the website: 13722360