Select a claim and then write a report to Dr. Lewis explaining why you support that claim. Claim 1: The sediment that formed the Great Plains came from the rock of the Rocky Mountains.
Claim 2: The magma that formed the Rocky Mountains came from the rock of the Great Plains.
Choose the claim that is best supported by evidence, explaining why the rock of the Rocky Mountains and Great Plains have surprisingly similar mineral compositions.

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

the answer is to check all of them! they all apply well at least i think so!

a is the best answer your welcome