Two beakers are on the same table in a laboratory • Beaker 1 contains 100 mL of boiling water
Beaker 2 contains 200 mL of boiling water
.
Whích choice describes the water in these beakers?
The water in beaker 1 has more thermal energy than the water in beaker 2
The water in beaker 2 has more thermal energy than the water in beaker 1.
The water in beaker 1 has a higher temperature than the water in beaker 2
The water in beaker 2 has a higher temperature than the water in beaker 1

Chapter 23, problem 075 the figure shows a geiger counter, a device used to detect ionizing radiation (radiation that causes ionization of atoms). the counter consists of a thin, positively charged central wire surrounded by a concentric, circular, conducting cylindrical shell with an equal negative charge. thus, a strong radial electric field is set up inside the shell. the shell contains a low-pressure inert gas. a particle of radiation entering the device through the shell wall ionizes a few of the gas atoms. the resulting free electrons (e) are drawn to the positive wire. however, the electric field is so intense that, between collisions with gas atoms, the free electrons gain energy sufficient to ionize these atoms also. more free electrons are thereby created, and the process is repeated until the electrons reach the wire. the resulting "avalanche" of electrons is collected by the wire, generating a signal that is used to record the passage of the original particle of radiation. suppose the radius of the central wire is 24 âµm, the inner radius of the shell 2.3 cm, and the length of the shell 14 cm. if the electric field at the shell's inner wall is 2.8 ă— 104 n/c, what is the total positive charge on the central wire?

Which of the following statements are true for an isothermal process? check all that apply. - during an isothermal process, the work done by the gas equals the heat added to the gas. - during an isothermal process, the internal energy of the system changes. - an isothermal process is carried out at constant temperature. - an isothermal process is carried out at constant pressure. - an isothermal process is carried out at constant volume.

Astudent pushes a 40-n block across the floor for a distance of 10 m. how much work was applied to move the block? a. 4 j b. 40 j c. 400 j d. 4000 j