Physics, 03.06.2021 16:10 cody1097

PLEASE HELP ME WITH THIS! CURRENT ELECTRICITY TEST 74 POINTS
(Show your work and include all units in your answer.)

A resistor is connected to a 40V power supply. An ammeter measures a current of 2.0A going through it. Determine the resistance. [2 marks]

A circuit has a current of 10A. The wire has a resistance of 9Ω. Determine the voltage across the energy source. [2 marks]

The circuit below contains two identical lamps. The total resistance of the circuit is 30Ω. The voltage drop across the battery is 6.0V.

a) Calculate the current in the circuit. [2 marks]
b) Calculate the voltage of each lamp. [2 mark]
c) Calculate the resistance of each lamp. [2 mark]
The circuit below has three identical lamps. The current coming out of the battery is 4A. The total resistance of the circuit is 9Ω.

a) Calculate the voltage of the battery. [2 marks]

b) Calculate the voltage of each lamp. [2 marks]

#10 Draw a schematic diagram of a circuit consisting of a two-cell battery, a resistor, a lamp and a motor all connected in series. Attach a switch to control the circuit, an ammeter to measure the current after the motor and a voltmeter to measure the voltage across the resistor. 10- MARKS

# 11 Draw a schematic diagram of a circuit consisting of a two-cell battery, two motors and two lamps. If one of the lamps is unscrewed the other lamp should also turn off. If one of the motors is disconnected the other one should stay on. Include a switch that controls the whole system, an ammeter to measure the current coming out of the power supply and a voltmeter to measure the voltage drop across the power supply 10 MARKS

Answers: 2

Show answers

Another question on Physics

Physics, 21.06.2019 14:30

If 1 lb of fat is stored by the body for each 14.6×103kj of excess nutritional energy consumed, how long will it take this person to gain 1 lb?

Answers: 2

Answer

Physics, 22.06.2019 00:30

Part f - example: finding two forces (part i) two dimensional dynamics often involves solving for two unknown quantities in two separate equations describing the total force. the block in (figure 1) has a mass m=10kg and is being pulled by a force f on a table with coefficient of static friction îľs=0.3. four forces act on it: the applied force f (directed î¸=30â above the horizontal). the force of gravity fg=mg (directly down, where g=9.8m/s2). the normal force n (directly up). the force of static friction fs (directly left, opposing any potential motion). if we want to find the size of the force necessary to just barely overcome static friction (in which case fs=îľsn), we use the condition that the sum of the forces in both directions must be 0. using some basic trigonometry, we can write this condition out for the forces in both the horizontal and vertical directions, respectively, as: fcosî¸â’îľsn=0 fsinî¸+nâ’mg=0 in order to find the magnitude of force f, we have to solve a system of two equations with both f and the normal force n unknown. use the methods we have learned to find an expression for f in terms of m, g, î¸, and îľs (no n).

Answers: 2

Answer

Physics, 22.06.2019 13:20

Arrange the images in order to show how lake-effect snow occurs.

Answers: 2

Answer

Physics, 22.06.2019 15:50

If the work required to stretch a spring 3 ft beyond its natural length is 15 ft-lb, how much work is needed to stretch it 27 in. beyond its natural length?

Answers: 1

Answer

You know the right answer?

PLEASE HELP ME WITH THIS! CURRENT ELECTRICITY TEST 74 POINTS
(Show your work and include all...

Questions