subject
Physics, 29.07.2021 14:00 robert7248

The heat required to raise 3 kg of copper from 0°C to 10°C raises 1kg of lead from 10°C to 100°C. If the specific heat capacity of copper is 0.095 cal/g°C, find the specific heat capacity of lead.​

ansver
Answers: 3

Another question on Physics

question
Physics, 21.06.2019 20:40
In a steady-flow steam power plant system, two adiabatic high-pressure and low-pressure turbines ane used to generate power. superheated steam enters the high-pressure turbine at 8 mpa and 550°c. the steam expands in the high-pressure turbine to a saturated vapor at 3 mpa. in order to increase the powe generation of the power plant, another steam turbine working in a lower pressure ranges is deployed. the outlet vapor from the first turbine is heated up at a boiler to the temperature of 500 c at the constant pressure of first turbine's outlet (3 mpa). then, the vapor enters the second turbine and produces extra work. the exit conditions of the second turbine are 5o kpa and 90 percent quality. if the total power output of the power plant is 25 mw, determine a) the mass flow rate of the water (kg/s). b) heat transfer rate in the boiler (mw). (30 points) 3 mpa 00 c 8 mpa s0 c high pres turbine low pres boiler turbine 50 kpa 3 mpa 09 saturated vapor t heat engine, shown in the figure, operates between high temperature and low temperature of through a heat 4. a carnot tn and tu respectively. this heat engine receives energy from a heat reservoir at t exchanger where the heat transferred is proportional to the temperature difference as ? = k (z,-7, ). it rejects heat at a given low temperature tl. to design the heat engine for maximum work output, find the high temperature, th, as a function of tes and t. (15 points) qe
Answers: 3
question
Physics, 22.06.2019 01:10
The 10-kg double wheel with radius of gyration of 125mm about o is connected to the spring of stiffness k = 600 n/m by a cord which is wrapped securely around the inner hub. if the wheel is released from rest on the incline with the spring stretched 225 mm, calculate the maximum velocity v of its center o during the ensuing motion. the wheel rolls without slipping
Answers: 1
question
Physics, 22.06.2019 05:30
What is a neurotransmitter involved in mood reward, addiction, and motor behaviors?
Answers: 3
question
Physics, 22.06.2019 11:50
Find the dimensions and area of the largest rectangle that can be inscribed in the upper half of the ellipse. (give your answers in terms of a and b. enter the dimensions as a comma-separated list.)
Answers: 2
You know the right answer?
The heat required to raise 3 kg of copper from 0°C to 10°C raises 1kg of lead from 10°C to 100°C. If...
Questions
question
Advanced Placement (AP), 07.12.2020 22:50
question
Biology, 07.12.2020 22:50
Questions on the website: 13722359