Which type of alternate air source does not necessarily require the donor to give up his primary second stage? Technical diving configuration. Alternate-air-source inflator. Conventional alternate-air-source second stage. None of the above

Steam is generated in a boiler of a cogeneration plant at 10 mpa and 450°c at a steady rate of 5 kg/s. in normal operation, steam expands in a turbine to a pressure of 0.5 mpa and is then routed to the process heater, where it supplies the process heat. steam leaves the process heater as a saturated liquid and is pumped to the boiler pressure. in this mode, no steam passes through a condenser, which operates at 20 kpa. (a) determine the power produced in the turbine and the rate at which process heat is supplied in this mode. (b) determine the power produced in the turbine and the rate of process heat supplied if only 60 percent of the steam is routed to the process heater and the remainder is expanded to the condenser pressure. (3.32 mw; 9.69 mw; 4.25 mw; 5.82 mw)

Which configuration would produce an electric current? a) rotate a coil of copper wire between two magnets. b) connect a wire between a copper and zinc strip sitting in a beaker of water. c) connect a wire to the (+) positive end of a battery and the other end to a light bulb. d) connect a wire to the negative end of a battery and the other end to a light bulb.

Aresistor with an unknown resistance is connected in parallel to a 9 ω resistor. when both resistors are connected in parallel to an emf source of 21 v, the current through the unknown resistor is measured with an ammeter to be 4 a. what is the resistance of the unknown resistor? answer in units of ω.