Physics, 17.08.2021 19:00 25linm

Three blocks are shown. Which statement is correct? Block A has the greatest density.
Block B has the greatest density.
The density of Block A is equal to the density of Block B.
The density of Block B is equal to the density of Block C.

Three blocks are shown. Which statement is correct?

Block A has the greatest density.
Block B has

Answers: 2

Show answers

Another question on Physics

Physics, 22.06.2019 16:50

Which best describes the first law of thermodynamics as compared to the second law of thermodynamics? a. the first law describes how thermal energy is conserved but not the direction it moves. b. the first law describes the direction thermal energy moves but not how it is conserved. c. the first law describes how thermal energy can be created but not how it can be destroyed. d. the first law describes how thermal energy can be destroyed but not how it can be created.

Answers: 1

Answer

Physics, 23.06.2019 00:30

Diego kicks a soccer ball from the end line. his fellow students time and mark the soccer ball as it moves down the field. the graph represents the ball's progress. based on the graph, during what time is the velocity constant and positive?

Answers: 1

Answer

Physics, 23.06.2019 06:00

How can you improve the percent yield of copper in this lab? check all possible strategies that will you do so. measure reactants precisely. stir to the reaction take place. chill the reactants before combining them. wait patiently until the reaction completes. make sure to recover as much copper as possible.

Answers: 1

Answer

Physics, 23.06.2019 07:00

Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater.what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?

Answers: 3

Answer

You know the right answer?

Three blocks are shown. Which statement is correct? Block A has the greatest density.
Block B...

Questions