Physics, 07.10.2021 08:00 genyjoannerubiera
the hydraulic crane is used to lift the 1360-lblb load. determine the force in the hydraulic cylinder abab and the force in links acac and adad when the load is held in the position shown. (figure 1)
Answers: 2
Physics, 22.06.2019 11:00
Aperson walks first at a constant speed of 4.89 m/s along a straight line from point a to point b and then back along the line from b to a at a constant speed of 2.95 m/s. what is the average speed over the entire trip?
Answers: 1
Physics, 22.06.2019 12:00
Asolid round steel rod 6.25 mm in diameter and 375 mm long is rigidly bonded to the end of solid square brass rod 25 mm on a side and 300 mm long. the geometric axes of the bare are along the same line. an axial tensile force of 5.4 kn is applied at the extreme ends of the assembly. for steel e = 200 gpa and for brass e = 90 gpa. determine the total elongation for the assembly.
Answers: 1
Physics, 22.06.2019 22:00
Hat is the most commonly cited cause of occupational injuries in the healthcare sector? a. repositioning of patients b. manual pipetting c. slips and trips d. workplace violence
Answers: 3
Physics, 23.06.2019 01:30
When a lead acid car battery is recharged by the alternator, it acts essentially as an electrolytic cell in which solid lead(ii) sulfate is reduced to lead at the cathode and oxidized to solid lead(ii) oxide at the anode. suppose a current of is fed into a car battery for seconds. calculate the mass of lead deposited on the cathode of the battery.
Answers: 3
the hydraulic crane is used to lift the 1360-lblb load. determine the force in the hydraulic cylinde...
Social Studies, 28.07.2019 09:00
Social Studies, 28.07.2019 09:00
Physics, 28.07.2019 09:00
History, 28.07.2019 09:00
Biology, 28.07.2019 09:00
History, 28.07.2019 09:00