A homemade capacitor is constructed of 2 sheets of aluminum foil with an area of 2.00 square meters, separated by paper, 0.05 mm thick, of the same area and a dielectric constant of 3.7. The homemade capacitor is connected in series with a resistor, a switch, and a 6.00-V voltage source. (a) What is the RC time constant of the circuit

Steam is generated in a boiler of a cogeneration plant at 10 mpa and 450°c at a steady rate of 5 kg/s. in normal operation, steam expands in a turbine to a pressure of 0.5 mpa and is then routed to the process heater, where it supplies the process heat. steam leaves the process heater as a saturated liquid and is pumped to the boiler pressure. in this mode, no steam passes through a condenser, which operates at 20 kpa. (a) determine the power produced in the turbine and the rate at which process heat is supplied in this mode. (b) determine the power produced in the turbine and the rate of process heat supplied if only 60 percent of the steam is routed to the process heater and the remainder is expanded to the condenser pressure. (3.32 mw; 9.69 mw; 4.25 mw; 5.82 mw)

A3030 cmcm wrench is used to loosen a bolt with a force applied 0.30.3 mm from the bolt. it takes 6060 nn to loosen the bolt when the force is applied perpendicular to the wrench. how much force would it take if the force was applied at a 3030 degree angle from perpendicular? a 3030 cmcm wrench is used to loosen a bolt with a force applied 0.30.3 mm from the bolt. it takes 6060 nn to loosen the bolt when the force is applied perpendicular to the wrench. how much force would it take if the force was applied at a 3030 degree angle from perpendicular?

In a heat engine if 1000 j of heat enters the system the piston does 500 j of work, what is the final internal energy of the system if the initial energy was 2000 j? 1. write the equation 2.list out your known variables 3.plug the numbers into the equations 4.solve 5.write your solution statement that includes initial energy and final