Twenty-two 14 AWG copper conductors are run in conduit. Each conductor has type THHN insulation. the conduit is located in an area with an ambient temperature of 101oF. What is the ampacity of each conductors

How do the measurements of charge at the different locations on the sphere compare to each other? the charge measurements are different at all locations on the sphere. the charge measurements are virtually not the same at all locations on the sphere except for the charge at the very top and at the very bottom that are equal. the charge measurements are virtually the same at all locations on the sphere except for the charge at the very top. at the top, the conductive sphere has a small disk that is made of different material. the charge measurements are the same at all locations on the sphere. what happens to the charge on the conductive sphere when it is connected to a source of charge such as the electrostatic voltage source? nothing will happen because no charge goes around the surface of the sphere. the charge on the conductive sphere spreads out over the surface of the sphere; being greater in some specific locations on the sphere. the charge on the conductive sphere spreads out uniformly over the surface of the sphere. the charge on the conductive sphere spreads out non-uniformly over the surface of the sphere.

The x-coordinate of a particle in curvilinear motion is given by x = 3.1t3 - 4.9t where x is in feet and t is in seconds. the y-component of acceleration in feet per second squared is given by ay = 2.3t. if the particle has y-components y = 0 and vy = 5.0 ft/sec when t = 0, find the magnitudes of the velocity v and acceleration a when t = 1.8 sec. sketch the path for the first 1.8 seconds of motion, and show the velocity and acceleration vectors for t = 1.8 sec. answers: v = ft/sec a = ft/sec2

Asatellite component is in the shape of a cube with 10cm edges, has an evenly distributed mass of 2 kg and one bolt hole at each of four corners. if the maximum predicted random vibration environment is 10 grms, what bolt size would be a good choice for restraint? what other factors might drive bolt size besides force/stress?