subject
Physics, 25.11.2021 19:20 wdw52001

A car pulls away from an intersection when the light turns green. After uniformly accelerating for the next 6.0 s, the car has traveled a distance of 75 m. The car then proceeds at a constant speed. ( /7) (a) What was the car's acceleration?
(b) How fast was the car traveling when it finished accelerating?
(c) How long will it take for the car to travel another 85 m at this constant speed?

ansver
Answers: 2

Another question on Physics

question
Physics, 22.06.2019 15:10
An important dimensionless parameter concerned with very high-speed flow is the mach number, defined as v/c, where v is the speed of the object such as an airplane or projectile, and c is the speed of sound in the fluid surrounding the object. for a projectile traveling at 1170 mph through air at 50 ˚f and standard atmospheric pressure, what is the value of the mach number?
Answers: 2
question
Physics, 22.06.2019 17:20
You charge a parallel-plate capacitor, remove it from the battery, and prevent the wires connected to the plates from touching each other. when you increase the plate separation, what happens to the following quantities?
Answers: 1
question
Physics, 23.06.2019 00:50
which statements describe the image? check all that apply.the wood is releasing argon gas.this information is useful for dating ancient rock.the process works only with organic matter.the element has a half-life of 5,730 years.this shows the half-life of carbon-19.
Answers: 1
question
Physics, 23.06.2019 07:00
Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater.what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?
Answers: 3
You know the right answer?
A car pulls away from an intersection when the light turns green. After uniformly accelerating for t...
Questions
question
Mathematics, 02.10.2019 12:30
Questions on the website: 13722363