A sample of material with a volume of 10.2 m^3 is heated from 15 °C to 100 °C and its volume is now 10.236414 m^3. What is the coefficient of volume expansion of the material?

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

speed of light in vacuum is 300,000 km/s

speed of light in other mediums is given by the expression v = c/n, where c is the speed of light in vacuum and n is the refractive index of medium.

for the first medium v = 200,000 km/s

  so, refractive index of medium = 300000/200000 = 1.5

    1.5 refractive index is usually for glass. so first medium is glass.

for the second medium v = 250,00 km/s

so, refractive index of medium = 300000/250000 = 1.2

    1.2 refractive index is usually for water. so second medium is water.

for the third medium v = 0 km/s

so, refractive index of medium = 300000/0 = ∞

    ∞ refractive index is usually for opaque mediums. so third medium is opaque medium.

54 degrees incident angle = reflected angle

angle is from normal turned to line of ray

it is given that trillions of microbes make up to 1% to 3% of the body mass.

let's take average of this percentage: 2%

consider the average mass of the human body as 70 kg.

then, trillions of microbes would have mass  

therefore, 100 trillion micro-organisms would weigh:

this is an approximate value and could change depending on the mass of the human body and percentage of the microbes present in it.

average mass per microorganism =