The sentences below describe how the Grand Canyon formed. Put them in the correct order from oldest (1) to youngest/most recent (7). The sediments were compressed into sedimentary rocks.

The Colorado River cut down through the sedimentary rock layers to form the Grand Canyon.

There was a shallow ocean that deposited sediments.

Snow melt from the Colorado Rocky Mountains eventually formed the Colorado River.

Pacific ocean crust was pushed under the North American continent to create the Colorado Plateau (a high, flat area).

The mountains eroded down to very low hills.

There were ancient mountains taller than the Himalayan Mountains.

Astone is dropped with no initial velocity from the top of a cliff and hits the ground a time of 3.9 s later. what is the height of the cliff, in units of meters? you may assume that air resistance is negligible. give the answer as a positive number question 15 a figure skater is rotating at a rate of 200 revolutions per minute. what is the angular speed, in units of rad/s? 200 o 20.9 12000 o 3.33

In all trials, the magnitude of the final velocity for g1 + g2 was less than the magnitude of any initial velocity. as mass increased, what happened to the velocity? the velocity decreased. the velocity increased. the velocity of g1 + g2 could not be measured. the velocity was not affected by the mass increase.

As part of an industrial process, air as an ideal gas at 10 bar, 400k expands at steady state through a valve to a pressure of 4 bar. the mass flow rate of air is 0.5 kg/s. the air then passes through a heat exchanger where it is cooled to a temperature of 295k with negligible change in pressure. the valve can be modeled as a throttling process, and kinetic and potential energy effects can be neglected. (a) for a control volume enclosing the valve and heat exchanger and enough of the local surroundings that the heat transfer occurs at the ambient temperature of 295 k, determine the rate of entropy production, in kw/k. (b) if the expansion valve were replaced by an adiabatic turbine operating isentropically, what would be the entropy production? compare the results of parts (a) and (b) and discuss.