The tape in the tape lab was charged by because
conduction I started with 1 neutral tape and 1 negatively charged desk and ended with 1 neutral de
х
adduction... 1 positively charged piece of tape and one negatively charged piece of tape were
induction... the 2 neutral pieces of tape were near each other but not touching, so both became negativ
friction I started with 2 neutral charges and ended with a negative charge on the tape and a positive

Ahollow metal sphere has 6 cm and 11 cm inner and outer radii, respectively. the surface charge density on the inside surface is −100nc/m2. the surface charge density on the exterior surface is:

Which type of circuit is becoming more common in residential electrical design and construction? a. hazardous-area circuit b. three-phase circuit c. 480-volt circuit d. communication circuit

Aroll in a paper machine is powered by a separately excited dc machine. operating point 1 (under load): the roll typically operates at 764 rpm and must provide 301 nm of torque to oppose the load of the paper. the armature voltage is 230v for this operating point operating point 2 (no load): when the load is removed the speed of the roll increases to 900 rpm (the field characteristics are unchanged) la ea dev m (a) calculate the maximum torque (units of nm) that the motor can supply with this applied voltage (b) calculate the value of the armature resistance, ra (in ohms) (c) at operating point 1 (loaded condition), the field current, i, and the total input power (armature field), are measured to be to be 10 a and 28,600 w respectively. use this information to calculate the value of the field resistance, rf (in ohms). (d) (d) at operating point 1 (loaded condition), calculate the motor efficiency. express your answer as a percent to at least 2 significant digits. (d) if the field voltage is reduced by 1/2, calculate the new stall torque (in nm) of the motor (f). if the field voltage is reduced by 1/2, calculate the new no-load speed (in rad/sec)