A mild steel ring of cross-sectional area 4 cm2 has a radial air-gap of 3 mm cut into it. If the mean length of the mild steel path is 300 mm, calculate the mag- netomotive force to produce a flux of 0.48 mWb. (Use the B–H curve

In a wind tunnel the speed changes as the cross sectional area of the tunnel changes. if the speed in a 6' x 6' square test section is 100 mph, what was the speed upstream of the test section where the tunnel measured 20' x 20'? use conservation of mass and assume incompressible flow. conservation of mass requires that as the flow moves through a path or a duct the product of the density, velocity and cross sectional area must remain constant; i.e., that ova-constant. a model is being tested in a wind tunnel at a speed of 100 mph if the flow in the test section is at sea level standard conditions, what is the pressure at the model's stagnation point? (a) the tunnel speed is being measured by a pitot-static tube connected to a u- tube manometer. what is the reading on that manometer in inches of water? (b) at one point on the model a pressure of 2058 psf is measured. what is the local airspeed at that point?

Which of the following changes will result in a stronger electromagnet? a. using fewer coils of wire b. using a higher voltage c. using a shorter nail d. using a longer wire

During which interval are the persons represented by the graph not moving? a) 0 to 0.5 hrs b) 1.5 to 2 hrs c) 2 to 2.5 hrs d) 4.5 to 5 hrs