Identify the direction (from high to low, from low to high) that heat is normally transferred and give an example. (will give brainliest)

Suppose that two tanks, 1 and 2, each with a large opening at the top, contain different liquids. a small hole is made in the side of each tank at the same depth 1.57 m below the liquid surface, but the hole in tank 2 has 2.49 times the cross-sectional area of the hole in tank 1. (a) what is the ratio ρ1/ρ2 of the densities of the liquids if the mass flow rate is the same for the two holes? (b) what is the ratio rv1/rv2 of the volume flow rates from the two tanks? (c) at one instant, the liquid in tank 1 is 14.9 cm above the hole. if the tanks are to have equal volume flow rates, what height above the hole must the liquid in tank 2 be just then?

Atwo-stage air compressor operates at steady state, compression 10m^3/min of air from 100 kpa and 300k to 1200 kpa. an intercooler between the two stages cools the air to 300k at a constant pressure of 350 kpa. the compression processes are isentropic. a) calculate the power required to run the compressor, in kw b) compare the result to the power required for isentropic compression from the same inlet state to the same final pressure.

This is important 1. what happens to the speed of molecules in water vapor when it condenses to form a liquid? (2 points) the molecules slow down. the molecules speed up. the molecules slow down and then speed up. the molecules speed up and then slow down. 2. how might human activities change to compensate for a decrease in water supplies? (2 points) humans might build a factory. humans might build drainage systems. humans might extract more water from the ground. human behavior does not change because of the water cycle. i'll be grateful if anyone can answer these 2 questions !