Physics, 01.08.2019 22:00 kittycat92

Why do you rotate when you hold a spinning wheel?

Answers: 1

Show answers

Another question on Physics

Physics, 21.06.2019 14:10

Ok i am attempting to my niece attach a galvanized wire (like a tether for a dog) at the corner of two fences, making a tightwire if you will and we drilled a hole in a softball and she hits it. the ? and problem is that we can not get the wire taunt enough where it doesnt sag after hitting the ball once, and the wire sags and wobbbles. its a 15 ft rubber covered galvanized wire and one can adjust the length of the placing of the wire by having it make the corner of 2 fences become a it can be adjusted, however, with all our human strength and pliers we could not make it taunt as possible. is there anything other that attaching it to a car to do this. sorry abt the length but it would mean the world to my niece if i could solve this came up with the entire idea herself, and she is 14 and paid for the wire and did as much work as i did drilling a hole through a softball wide enough for attaching piece at each end of the wire that clips on to the fence. . any ideas welcome if serious. but awesome if it is a fact. much obliged. bucky bukowski buckman

Answers: 3

Answer

Physics, 22.06.2019 16:30

Atank has a shape of a cone with a radius at the top of 2 m and a height of 5 m. the tank also has a 1 m spout at the top of the tank. the tank is filled with water up to a height of 2 m. find the work needed to pump all the water out the top of the spout. (use 9.8 m/s2 for g and the fact that the density of water is 1000 kg/m3.)

Answers: 1

Answer

Physics, 22.06.2019 18:00

Asynthetic fiber used in manufacturing carpet has tensile strength that is normally distributed with mean 75.5 psi and standard deviation 3.5 psi. how is the standard deviation of the sample mean changed when the sample size is increased from n equals 8 to n equals 47

Answers: 2

Answer

Physics, 22.06.2019 19:30

Amass m = 74 kg slides on a frictionless track that has a drop, followed by a loop-the-loop with radius r = 18.4 m and finally a flat straight section at the same height as the center of the loop (18.4 m off the ground). since the mass would not make it around the loop if released from the height of the top of the loop (do you know why? ) it must be released above the top of the loop-the-loop height. (assume the mass never leaves the smooth track at any point on its path.) 1. what is the minimum speed the block must have at the top of the loop to make it around the loop-the-loop without leaving the track? 2. what height above the ground must the mass begin to make it around the loop-the-loop? 3. if the mass has just enough speed to make it around the loop without leaving the track, what will its speed be at the bottom of the loop? 4. if the mass has just enough speed to make it around the loop without leaving the track, what is its speed at the final flat level (18.4 m off the ground)? 5. now a spring with spring constant k = 15600 n/m is used on the final flat surface to stop the mass. how far does the spring compress?