subject
Physics, 03.08.2019 17:30 Jinesha

How could using a large book as the displacement object produce significant error in your results

ansver
Answers: 1

Another question on Physics

question
Physics, 22.06.2019 18:30
Which of the following is not a means to accelerating? question 4 options: a)increase speed b)remain still c)decrease speed d)change direction
Answers: 1
question
Physics, 22.06.2019 19:30
Amass m = 74 kg slides on a frictionless track that has a drop, followed by a loop-the-loop with radius r = 18.4 m and finally a flat straight section at the same height as the center of the loop (18.4 m off the ground). since the mass would not make it around the loop if released from the height of the top of the loop (do you know why? ) it must be released above the top of the loop-the-loop height. (assume the mass never leaves the smooth track at any point on its path.) 1. what is the minimum speed the block must have at the top of the loop to make it around the loop-the-loop without leaving the track? 2. what height above the ground must the mass begin to make it around the loop-the-loop? 3. if the mass has just enough speed to make it around the loop without leaving the track, what will its speed be at the bottom of the loop? 4. if the mass has just enough speed to make it around the loop without leaving the track, what is its speed at the final flat level (18.4 m off the ground)? 5. now a spring with spring constant k = 15600 n/m is used on the final flat surface to stop the mass. how far does the spring compress?
Answers: 3
question
Physics, 22.06.2019 23:10
Ablue car pulls away from a red stop-light just after it has turned green with a constant acceleration of 0.5 m/s 2 . a green car arrives at the position of the stop-light 6.5 s after the light had turned green. if t = 0 when the light turns green, at what time does the green car catch the blue car if the green car maintains the slowest constant speed necessary to catch up to the blue car? answer in units of s.
Answers: 1
question
Physics, 23.06.2019 02:10
You have a resistor and a capacitor of unknown values. first, you charge the capacitor and discharge it through the resistor. by monitoring the capacitor voltage on an oscilloscope, you see that the voltage decays to half its initial value in 3.00 ms . you then use the resistor and capacitor to make a low-pass filter. what is the crossover frequency fc?
Answers: 1
You know the right answer?
How could using a large book as the displacement object produce significant error in your results...
Questions
question
History, 11.03.2020 22:48
question
History, 11.03.2020 22:48
question
Advanced Placement (AP), 11.03.2020 22:48
Questions on the website: 13722363