Which statement best explains why the specific heat of water is higher than the specific heat of most other substances? a) due to its polarity and hydrogen bonding water can absorb heat without a significant temperature change. b) due to the ionic bonding in liquid water, it takes more heat energy to reach boiling. c) because water is a covalent compound, it takes a lot of energy to change its kinetic energy. d) water has a higher density value than most substances and requires more energy to change the temperature.

Apulley with a mechanical advantage of 5 will require you to pull times the amount of rope. a. 1/5 b. 5 c. 10 d. 15

Achemistry student needs of 40ml diethylamine for an experiment. by consulting the crc handbook of chemistry and physics, the student discovers that the density of diethylamine is 0.7 . calculate the mass of diethylamine the student should weigh out. round your answer to significant digits.

Aroll in a paper machine is powered by a separately excited dc machine. operating point 1 (under load): the roll typically operates at 764 rpm and must provide 301 nm of torque to oppose the load of the paper. the armature voltage is 230v for this operating point operating point 2 (no load): when the load is removed the speed of the roll increases to 900 rpm (the field characteristics are unchanged) la ea dev m (a) calculate the maximum torque (units of nm) that the motor can supply with this applied voltage (b) calculate the value of the armature resistance, ra (in ohms) (c) at operating point 1 (loaded condition), the field current, i, and the total input power (armature field), are measured to be to be 10 a and 28,600 w respectively. use this information to calculate the value of the field resistance, rf (in ohms). (d) (d) at operating point 1 (loaded condition), calculate the motor efficiency. express your answer as a percent to at least 2 significant digits. (d) if the field voltage is reduced by 1/2, calculate the new stall torque (in nm) of the motor (f). if the field voltage is reduced by 1/2, calculate the new no-load speed (in rad/sec)