A. filtration B. sieving C. using a magnet D. decantation E. evaporation
Directions: Choose the best technique that can be used to separate the substances or
materials in each mixture. Write the letter of your answer on the space before the nu
1. Cornstarch and water
2. Iron and sulfur
3. Rice grains and stones
4. Pebbles and soil
5. Muddy water
6. Ground pepper and water
7. Flour and coarsely ground corn
8. Needles in a box of beads
9. Sesame seeds in soy sauce
10. Pebbles and iron nails
11. Fine sand from rocks
12. Sand from water
13. Gravel and sand
14. Salt and iron filings
15. Pins from assorted buttons
16. Coconut oil from coconut milk
17. Sand and pebbles
18. Pasta from water
19. Sand and thumb tacks
20. Salt solution

Consider three unlabeled bottles, each contain small pieces of one of the following metals. - magnesium - sodium - silver the following reagents are used for identifying the metals. - pure water - a solution of 1.0 molar hcl - a solution of concentrated hno3 (a) which metal can be easily identified because it is much softer than the other two? describe a chemical test that distinguishes this metal from the other two, using only one of the reagents above. write a balanced chemical equation for the reaction that occurs. (b) one of the other two metals reacts readily with the hcl solution. identify the metal and write the balanced chemical equation for the reaction that occurs when this metal is added to the hcl solution. use the table of standard reduction potentials (attached) to account for the fact that this metal reacts with hcl while the other does not. (c) the one remaining metal reacts with the concentrated hno3 solution. write a balanced chemical equation for the reaction that occurs. (d) the solution obtained in (c) is diluted and a few drops of 1 m hcl is added. describe what would be observed. write a balanced chemical equation for the reaction that occurs.

If the density of water is 1.0 g/cm3, which of these materials would float in water, based on their densities? check all that apply. aluminum cork iron lead wax

For the reaction, 4 a(g) + 3 b(g) => 2 c(g), the following data were obtained at constant temperature. experiment initial[a],mol/l initial [b],mol/l initial rate,m/min 1 0.200 0.150 5.00 2 0.400 0.150 10.0 3 0.200 0.300 10.0 4 0.400 0.300 20.0 which of the following is the correct rate law for the reaction? 1. rate = k[a]2[b]2 2. rate = k[a][b] 3. rate = k[a]2[b] 4. rate = k[a][b]2