Chemistry, 08.02.2021 23:10 ajahbraun

Using the phase diagram for H20, which of the following correctly describes water at 100°C and 1 atm pressure?
A. Liquid
B. At the boiling point
C. At the melting point
D. Gas
SUBMIT

Using the phase diagram for H20, which of the following correctly describes

water at 100°C and 1

Answers: 1

Show answers

Answers

Answer from: Quest

the tides are influenced by both the moon and the sun, it's easy to see that when the sun lines up with the moon and the earth, as during a new moon or full moon, the tidal effect is increased. these are known as spring tides, named not for the season, but for the fact that the water "springs" higher than normal. on the other hand, if the sun and the moon are 90 degrees apart in relation to an observer on earth as during the first quarter moon or third quarter moon, then high tides are not as high as they normally would be. this is because despite its greater distance, the sun's mass allows it to exert enough gravitational force on the oceans that it can negate some of the effects of the moon's pull. this phenomenon of lower high tides is called a neap tide. if you need more information on this topic visit moonconnection.com.

Answer from: Quest

Yes she is correct. the answer is completely correct

Answer from: Quest

explanation:

let the different atoms be x and y. each with four protons and same mass will be represented as follows.

mass number is number of protons + number of neutrons.

$^{m}_{4}x$ and $^{m}_4y$

since, it is given that one has a negative charge while the other is neutral. therefore, there will be increase in number of protons and the atom will be represented as follows.

$^{m}_{5}x^{-}$

according to periodic table, mass number of beryllium is 9 and it has atomic number 4 so, the atoms will be $^{9}_{5}be^{-}$ and $^{9}_{4}be$ .

the protons and neutrons will be located inside the nucleus whereas the electrons will be revolving around the nucleus.

Answer from: Quest

Answer : option c) heat is released during the process.explanation :

the enthalpy of formation of water is given as -285.8kj/mol, which states that the enthalpy of formation is negative.

negative enthalpy of formation indicates that the heat is released during the reaction process. the heat is released from reaction to the surroundings the enthalpy is expressed with a negative sign with the energy given out in the reaction process.

the formation of water takes place by giving out heat which is -285.8 kj/mol.

Another question on Chemistry

Chemistry, 22.06.2019 22:30

Which statement best summarizes the importance of ernest rutherford’s gold foil experiment? it proved that all of john dalton’s postulates were true. it verified j. j. thomson’s work on the atomic structure. it showed that an electron circles a nucleus in a fixed-energy orbit. it showed that a nucleus occupies a small part of the whole atom.

Answers: 1

Answer

Chemistry, 22.06.2019 23:30

The density of benzene at 15 °c is 0.8787 g/ml. calculate the mass of 0.1500 l of benzene at this temperature. enter your answer in terms of grams

Answers: 2

Answer

Chemistry, 23.06.2019 00:30

You are attempting to recrystallize a crude product mixture. you add the appropriate amount of hot solvent and are allowing the solution to slowly cool to room temperature. however, at room temperature no crystals have appeared, which of the following methods should be used to induce crystallization? choose all correct answers. a) place the flask in an ice bath. b) swirl the contents of the flask. c) add a small seed crystal of the desired product. d) scratch the inside of the glassware using a stir rod. it can be multiple choices

Answers: 3

Answer

Chemistry, 23.06.2019 01:00

Reactions in cells take place at about a. 40°c b. 0° c. 100°c d. 60°c

Answers: 1

Answer

You know the right answer?

Using the phase diagram for H20, which of the following correctly describes water at 100°C and 1 at...

Questions