Engineering, 06.09.2019 01:10 rousedem28381
Consider a surface-mount type transistor on a circuit board whose temperature is maintained at 35°c as shown in the figure below. air at 20°c flows over the upper surface of dimensions 4mm x 8mm with a convection coefficient of 50 w/m 2 . k. three wire leads, each of cross- section 1mm x 0.25mm and length 4mm, conduct heat from the base to the circuit board. the gap between the case and the circuit board is 0.2mm air transistor case wire lead circuit board gap
assuming the case is isothermal and neglecting radiation, estimate the case temperature when 150 mw is dissipated by the transistor and (i) stagnant air or (ii) a conductive paste fills the gap. the thermal conductivities of the wire leads, air, and conductive paste are 25,0.0263, and 0.12w/m - k, respectively.
Answers: 3
Engineering, 04.07.2019 18:10
The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false
Answers: 2
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
Engineering, 04.07.2019 18:10
Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?
Answers: 2
Engineering, 04.07.2019 18:10
What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information
Answers: 3
Consider a surface-mount type transistor on a circuit board whose temperature is maintained at 35°c...
Social Studies, 31.07.2019 10:00
Physics, 31.07.2019 10:00
Mathematics, 31.07.2019 10:00
Social Studies, 31.07.2019 10:00
Mathematics, 31.07.2019 10:00
Mathematics, 31.07.2019 10:00
History, 31.07.2019 10:00
Mathematics, 31.07.2019 10:00
Mathematics, 31.07.2019 10:00
Mathematics, 31.07.2019 10:00